Karcher MC 6550(N) User Manual - page 23
EN | 23
EN
three batteries keep at short power outages the real-time clock and the data stored in the proces-
sor. Please observe the correct polarity marked inside the battery compartment (“+” and “-”).
3.
Place the cover again onto the battery compartment and slide it opposite to the direction of the
arrow until it snaps in.
Inserting batteries into the remote control
Remove the battery compartment cover by pressing it down and sliding it outwards. Take
the cover of the battery compartment away. Insert two batteries type UM-4, 1.5V. Please
observe the correct polarity marked inside the battery compartment and on the batter-
ies (“+” and “-”). Place the cover over the compartment, press down lightly, and push it
upward until it snaps in.
Battery Safety Precautions
Please follow these safety instructions if handling batteries for this device:
•
Only use batteries of the same type and size.
•
Observe the polarity as marked in the battery compartment. Failure to properly align the battery
polarity can cause damages.
•
Do not mix different battery types (e.g. alkaline and zinc/carbon batteries) or exhausted and new
batteries.
•
Do not recharge normal batteries to avoid overheating and explosion.
•
Use alkaline batteries for extending the operating time of the batteries as much as possible.
•
During longer periods of non-use, please remove the batteries to avoid leaking.
General operating instructions
The settings described below refer to the control elements at the device. The settings are, if not
differently indicated, also possible with the remote control.
When connecting the plug with a power outlet for the first time, the appliance will be in the standby
mode and the STANDBY LED lights up. Instead of the time the indication flashes “-- --:-- --” on the
display. This is an indication that the time must be set.
Press the STANDBY/ ON button to turn the appliance on or to set it into standby mode. Pull the power
plug out of the wall socket if you want to switch off completely.
On/Off
•
By pressing STANDBY/ON you can set the device at any time into the standby mode. The
device is in standby mode if the current time is indicated and the blue background illumination is
dimmed. The STANDBY LED also lights up.
•
At the activated device, the blue background of the display lights up intensely and the STANDBY
LED extinguishes. The device is now ready for use. When turning on from standby mode to the
activated mode, the device continues with the last adjusted mode.
•
Select the audio source by repeated pressing of the FUNCTION key. The corresponding indica-
tion “CD”, “TAPE” or “TUNER” will light up.
•
Adjust the volume with VOLUME (UP or DOWN) (VOLUME + or – VOLUME on the remote
control).
•
Set the equalizer with the EQ button (“PASS”, “CLASSIC”, “ROCK”, “POP” or “JAZZ”).
•
During nonuse switch the device with STANDBY/ON back to the standby mode. In the standby
mode the current time is shown on the display.
•
The device is construed for continuous operation; it is either turned on or in standby mode.
•
If you don’t use the unit, please switch the device for power savings reasons into the standby
mode and pull the power plug.
Note:
If in the CD mode no signal is present, the device turns into standby within 15 minutes.
Batteries not
supplied