Karcher MC 6550(N) User Manual - page 26
26 | EN
•
To delete all the preset station press and hold the
►/|| PLAY /PAUSE button in standby mode
until the STA NDBY LED and the LCD will flash once.
Selecting a preset radio station
Select with BAND the desired frequency band.
•
Press the PRESET /FOLDER (◄ or ►) or PRESET FOL (UP or. DN) on the remote control, to
select the desired preset radio station.
•
The number of the radio station will be shown on the display together with its corresponding
frequency.
Recommendations for better reception
FM: For best reception fully unwind the FM wire antenna at the rear of the unit.
AM: The unit comes with a built-in ferrite antenna. For best reception change the direction of the unit.
Cassette operation
Cassette playback
To play a cassette first open the cover of the cassette player controls.
Be sure to tighten any slack tape in the cassette before use. Using either a pencil or a ball-point pen,
simply insert the pen or pencil into the centre of the spool and rotate to remove slackness.
Depress the OPEN button to open the cassette door.
Insert the cassette into the compartment with the open end facing downwards and full reel on the left
hand side, push the cassette well down and close the door.
Be sure not to touch the tape surface.
Select “TAPE” with the FUNCTION button and press the cassette PLAY ► button. To stop playback,
press the cassette STOP ■ button once. Remove the cassette carefully from the cassette tray.
Note:
Please press the cassette STOP ■ button quickly before it reaches the end of the tape in order to
prevent potential effects of tape.
Auto Stop
When the tape reaches its end in the playback, the built-in Auto Stop system releases the depressed
PLAY ► button. Only the cassette function is stopped automatically.
Notes on tapes
1.
Loose tapes may cause trouble. With a pencil etc. gently tighten the tape as
shown in Figure 1.
2.
Storage of tapes:
Do not store tapes in places which are subject to direct sunlight or near equip-
ment that generates heat; keep cassette tapes away from magnetic fields.
3.
120-minute tapes:
Since 120-minute tapes are very thin, the tape could be easily damaged or cut.
4.
Endless tape:
Do not use endless tapes, as this could damage the mechanism of the unit.
5.
Cleaning tape heads:
For maintaining the best condition of the deck and for a longer
lifespan always keep the head, capstan and pinch rollers clean.
Clean as follows:
1. Open the cassette compartment.
2. Use a cotton swab dipped in alcohol to clean the head, cap-
stan and pinch roller carefully.
Note: When cleaning, pay special attention not to damage any components.
(Fig.1)
Q-TIP
SOUND HEAD TRACK
PIN ROLLER
Drive
Mechanism