Karmann Colorado Operating Instructions Manual - Living Accommodation
Table in the rear seating group
Seat belts in the body seating group
Safety belts in the rear
LIVING ACCOMMODATION
4-2
Adjusting the table height
To adjust the height, push the lever under the
table surface to the left.
Push strongly against the tabletop at the
column location in order to lower the table.
Lock at the desired height by pressing the
lever to the right.
If the lever is again pressed to the left, the
tabletop will automatically return to its
original position by means of a gas pressure
spring. Support the tabletop with one hand in
order to prevent it from coming up suddenly.
Use knurled screw A in order to free the
tabletop for rotation and to lock it again.
A
Body seating group
The seating group is equipped with two
three-point automatic seat belts in the
direction of travel as standard. Lap belts
against the direction of travel are available
as standard.
Note
Seat belts may only be installed by a
specialist dealer.
The safety belts in the rear seating group are
fixed to a rail on the side walls under the
upholstery.
Note
A maximum of two pairs of belts can be
installed on each bench. Use an authorised
installer.