Karmann Colorado Operating Instructions Manual - Water Supply and Disposal

Fresh water supply

WATER SUPPLY AND DISPOSAL

7-2

Discharge tap for fresh water

The discharge tap for fresh water is in the

outer storage box.

Remove the cleaning closure of the tank and

pull out the discharge plug. The second tank

(optional) is supplied with a separate plug. 

Pump for fresh water system

The Colorado has a pump which supplies the

necessary pressure to the fresh water

system. In the Colorado 550, 650, 675TI

models this pump is located under the table

in the technical equipment space.  In the

Colorado 600 and 660 it is on the passenger

body in the storage compartment next to the

kitchen, and in the Colorado 625TI, 655TI, 

665 TI it is under the bench seat.

Filter (A) should be cleaned at least once a

year under running water. Discharge the

fresh water from the system before cleaning

the filter. 

Notes

Empty the fresh water tank as described

above. Open all taps into the central

position between "hot" and "cold" and

pump out the water remaining in the

pipes.

Then switch off the pump and separate

the pipe system from the inlet and outlet of

the pump (inlet connection: double wing

rotary connector piece / discharge

connection: stainless steel clip).

Lay down a cloth in the region of the

pump. Switch the pump on again and

empty the pump itself.

Notes 

Only use clean water to fill the fresh water

tank.

Do not reattach the pipes to the pump 

while it is decommissioned.

All taps should remain open in order 

to prevent damage.

Caution