Kauoheng KH-313 SERIES Operation Manual - 1-7
For the knitting needles in unused you don’t need to dismantle them.
All you have to do is to push them in the unactive position. In Fig.5.2
take out the steel wire firstly, and push to the shown area and replace
the steel wire.
Fig.5.2 Unworked position
5.2 KH-313J&TJ needle bed
The structure of the front and rear needle bed is the same. KH-313J
is with regular needles high butt and low butt. KH-313TJ is with
transfer needles high butt and low butt. They both have one kind of
jacks on front and rear needle beds.
Fig.5.3 The structure of front & rear needle bed
The unused butt needles and jacks you jacks you just push them
down to the unworked position. Of course you must pull out and
back the steel wire A & B for procedure.
Fig.5.4 Unworked position