KBL megaSun space 2000 Operating Instructions Manual - page 32
O p e r a t i n g I n s t r u c t i o n s | megaSun space 2000
32
Submenu call with START/ENTER. Displays the cur-
rent firmware version of the system components.
Do not operate the system with different
firmware versions!
•
All system components must be equipped
with an identical firmware version.
SERVICE
04/10
FIRMWARE-VERSIONS
> press enter
Submenu call with START/ENTER. Displays the first
and the last Software-Upload.
SERVICE
05/10
SOFTWARE UPLOAD
> press enter
Not available in this system.
>
SERVICE
06/10
RGB-Setup
SERVICE
07/10
SERVICE MODE
> press ENTER
Submenu SERVICE MODE.
Invoked by pressing
START (ENTER).
SUBMENU
SERVICE MODE
Service mode without tanning
Service mode with tanning
Troubleshooting mode.
The service mode is switched on for 30 minutes.
The mains voltage is connected. Error notifications
are ignored, but tanning cannot be started.
SERVICE
01/02
Service mode without tanning
> Start: press `ENTER` for 2s
Troubleshooting mode.
The service mode is switched on for 10 minutes.
The mains voltage is connected. Error notifications
are ignored, tanning can be started. After this pe-
riod, there is a 3 minute restart lockout.
SERVICE
02/02
Service mode with tanning
> Start: press `ENTER` for 2s
Show the characteristics of the device:
- Configuration code
- Variant code
- Serial number
SERVICE
08/10
SOLARIUM IDENTIFICATION
> press enter
Branches to further configuration options.
These settings must only be made by
trained service personnel!
SERVICE
09/10
SOLARIUM X-CODE
>
> PIN: