KeepGuard CAM User Manual - page 11
NOTE: If you choose daily report, you need to set the daily report
time:**H, **M.
21
TIPS:We have pre-set the parameters of some operators into the
camera. You just needs to select one of the operators, and the
camera will work and send MMS information according to the
preset phone number or email address. If the operator’s information
is not included in the camera, you must fill in the information. You
must select manual setting and set the parameters for the URL,
APN, IP and Port according to the settings the service provider
makes available. Please contact the network service provider if you
are not familiar with the settings.
Enter into “Send to” setting, you can set 5 phone numbers and 5 email
addresses.
The following shows how to set the
Sent to setting:
1. Press
MENU to display the setting menu.
2. Press
Right or Left until reach the “GPRS Setting” menu.
3. Press
UP or DOWN to select the “Send to”. Press OK to enter
submenu
4. Press
UP or DOWN to select Phone No or Email address.
4.Press
OK to enter into submenu. Press MENU to exit.
a b c
4. Press number button to key in the digits, Press # or * to switch
between digits,letters or punctuations.
Press “ ← ” to delete. Press OK to save all the current setting and return
to info display.
As is shown in the following charts:
The following shows how to set the Net Setting:
1. Press
MENU to display the setting menu.
2. Press
Right or Left until reach the “GPRS Setting” menu.
3. Press
UP and DOWN to select the Net setting. Press OK to enter
into the
Net Set Mode.Press UP and DOWN to select between Auto
Setting and Manual Setting. Press
OK to enter into the Net setting
menu.
4.Press UP or DOWN to select Auto Setting or Manual Setting.
5.Press OK to save current setting.Press MENU to exit.
Net setting
Send to setting
20
a
b
c
a
b