Keiser M7i Installation and operation manual - Computer Battery Replacement
M7i WHEELCHAIR-ACCESSIBLE TBT
16
WARNING: Do not connect improperly, charge or dispose of batteries in fire. Check local government
guidelines for battery disposal/recycling in your area. Battery leakage is extremely caustic and
contact with bare skin should be avoided. Follow battery manufacturer’s recommendations for
care and use.
COMPUTER BATTERY REPLACEMENT
M SERIES CARDIO CALIBRATION
“LO-BA” will appear on the computer to indicate that the batteries are low and
need replacement. To replace the batteries:
1. Remove the battery compartment screw using a #1 Phillips screwdriver (refer
to Figure 13). A flat, blunt object, such as a credit card may be used to pry
the cover from the rear of the computer housing.
2. Remove two D batteries (follow manufacturer's recommendations for handling,
maintaining, and disposing of batteries). Install two new D batteries observing
the correct polarity (see +/- marking inside the battery compartment).
3. Replace the battery compartment cover to the computer housing and
reinstall the screw.
All M Series equipment is factory calibrated with a tool. There is no need to calibrate. If a component associated with
the resistance mechanism or computer has been replaced, contact the Keiser Service Department for the calibration
procedure.
Figure 13. Battery Compartment
COMPLIANCE
This device complies with Industry Canada licence-exempt
RSS standard(s). Operation is subject to the following two
conditions: (1) this device may not cause interference, and
(2) this device must accept any interference, including
interference that may cause undesired operation of the
device.
Le present appareil est conforme aux CNR d’Industrie
Canada applicables aux appareils radio exempts de licence.
L’exploitation est autorisee aux deux conditions suivantes
: (1) l’appareil ne doit pas produire de brouillage, et (2)
l’utilisateur de l’appareil doit accepter tout brouillage
radioelectrique subi, meme si le brouillage est susceptible
d’en compromettre le fonctionnement.
REGULATORY NOTICE
NOTE: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following
measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and
receiver.
— Connect the equipment into an outlet on a circuit
different from which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician
for help.
- Changes or modifications not expressly approved by Keiser Corporation could void the user’s authority to operate the equipment.
- Upon end of life of this machine, be sure to remove the batteries and discard the machine according to your local laws and
regulations.
REGULATORY AND COMPLIANCE NOTICES
The Bluetooth
®
smart
word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of
such marks by Keiser is under license. Other trademarks and trade names are those of their respective owners.