Keiser M7i Installation and operation manual - page 9
M7i WHEELCHAIR-ACCESSIBLE TBT
09
BLUETOOTH
®
smart
M7i configuration of the region and machine ID number allows Bluetooth
®
smart
users to receive and download workout
information. This is a one-time setup procedure. NOTE: Steps 1 through 7 must be completed within one minute.
Begin with the computer off and push
Resistance Lever all the way down
towards you.
Pedal 1 full revolution to change the
TIME value to “2”.
Shift the Resistance Lever from end
to end (GEAR “1” to GEAR “88”) for
a total of 6 times.
Pedal 1 full revolution to change the
TIME value to “1”.
Shift the Resistance Lever down to
GEAR “19” for Miles, or up to GEAR
“21” for Kilometers.
Upon successful completion of
Steps 1–7, the region setting will
appear (“USA” or “EUro”). Once the
region has been set, the machine ID
number may be set as well. Proceed
to Step 9.
NOTE: If region setting was not
successful within one minute, allow
the computer to shut down (est.
time one minute) and restart the
procedure.
Shift the Resistance Lever up to
GEAR “21” for Miles, or GEAR “19” for
Kilometers.
Pedal 1 full revolution to change the
TIME value to “3”.
Move the Resistance Lever up to
increase, or down to decrease, the ID
number setting to any value between
1 and 200. Hold the ID number by
positioning the Resistance Lever to
any gear number between 8 and 16.
Allow the computer to shut down (est.
time one minute).
NOTE: The computer must shut down
to save and exit the Bluetooth setup
mode.
1
1x
2
3
1x
4
1x
6
GEAR “1”
GEAR “88”
6x
7
9
GEAR 1 to 7
DECREASES
ID number
GEAR 8 to 16
HOLDS
ID number
GEAR 17 to 24
INCREASES
ID number
8
REGION
ID NUMBER
5