Keiser M7i Installation and operation manual - Introduction
M7i WHEELCHAIR-ACCESSIBLE TBT
04
1. Carefully cut shipping box along the dotted line located near the base.
2. Remove upper portion by lifting up and over the machine.
3. Cut shipping box straps that secure the M7i. Carefully tilt the M7i toward the rear until the transport wheels
make contact with the floor, then position the machine at the desired location.
4. Layout the components of the machine and compare them to the “Parts List” on page 5.
NOTE: If parts are missing or damaged contact your local dealer, distributor, or Keiser Corp. Service
Department.
Congratulations on the purchase of your new Keiser M7i Wheelchair-Accessible Total Body Trainer and welcome
to the Keiser family. Your new resistance system is a revolutionary way to exercise providing a smoother,
quieter, and more predictable workout. Our machines are engineered to help improve function and maximize
results. The Keiser M7i design and fitness technology place the wellness goals of any level within reach.
We commend you on your decision to work toward your health and wellness goals. For your safety, and to
ensure the best experience and maximum gains, please heed all warnings and follow all recommendations
before you begin exercise.
Yours in Health,
Keiser Corporation
The following tools and materials are required to assemble the machine but not supplied:
INTRODUCTION
WEIGHT AND FOOTPRINT
TOOLS AND MATERIALS REQUIRED
PLACEMENT OF THE M7i
Total Weight
Qty
1
1
1
Qty
1
1
1
Description
5 mm Hex Key
Torque Wrench (minimum 20 ft-lbs/27 Nm)
5 mm Hex Bit Socket
Description
HYDROTEX Acculube #2 lubricating grease
Paste or spray wax (apply after assembly)
Clean cloth
142 lbs (64.4 kg)
Length 39.4 in (1,000 mm) x Width 28 in (711 mm)
M7i Footprint
ASSEMBLY
36 in (914 mm)
36 in (914 mm)
36 in (914 mm)
36 in (914 mm)
TRAINING AREA
REAR
FRONT
FREE AREA
39.4 in (1,000 mm)
28 in (711 mm)
Figure 1. M7i Training Area
The minimum amount of required free area space around the M7i is 36
inches (914 mm) on all sides (see Figure 1 “Training Area”). When M7i
machines are positioned adjacent to each other, the free area may be
shared. Free area space at the rear of the machine is not required when
the M7i is positioned against a wall.