Kuschall KSL Service Manual - Service Manual
7
© Küschall AG, Switzerland | 2011-12
Service Manual
Seat
Seat
Adjusting the seat height
The seat height can only be adjusted by fitting a larger or smaller rear
wheel and at the same time using a larger or smaller front wheel fork.
Possible front seat heights:
SHv [mm]
450 - 510
As the seat angle is dictated by the design of the frame, the seat height rear
(SHh) also changes by 10 mm.
The following settings are possible:
i
To ensure that the frame is straight and the axles of the front
wheel forks are perpendicular to the ground, choose one of the
combinations listed in the table.
Replacing the seat cover
Difficulty:
Tools:
Ã
3,4, 5 8, 10
Remove mudguard or clothes guard by loosening
bolts .
Remove bolts on both sides of the seat cover.
Remove seat cover and replace with new one.
i
Owing to the tension inherent in the design of the frame, it may not
be possible to fit the seat cover. In this case the axle holders must be
undone.
Undo axle holders
Fit new seat cover using bolts .
Ensure the rear wheels are parallel,
Chap. Rear Wheels, ‹Ensuring the
rear wheels are parallel
›
,
and tighten axle holder bolts.
Fit mudguard or clothes guard using bolts .
à 7 Nm
à 4 Nm
Front seat height (SHv) according to front wheel and rear
wheel
SHv [mm]
possible SHh
[mm]
Rear wheel Frame
Front wheel
3''
4''
5''
450 - 500
400 - 480
24
‘‘
75°
D
C
B
90°
B
A
--
460 - 510
400 - 480
25‘‘
75°
E
D
C
90°
C
B
--
25''
24''
3''
4''
5''
A B C D E
75°
90°
1
2
3
1