Kuschall KSL Service Manual - Service Manual
8
© Küschall AG, Switzerland | 2011-12
Service Manual
Back
Backrest
Adjusting the backrest height
Readjusting the push handle/telescopic tube
Difficulty:
Tools:
Ã
3
8
Remove the backrest padding.
Remove the screw connection and adjust the desired height of the
push handle or the telescopic tube. Insert the screw connection
again and tighten the nut.
Carry out the same setting on both sides.
Refit the backrest padding.
i
If the desired height cannot be achieved, you must use a different
telescopic tube or push handle. If the backrest height is too high, the
backrest tube can be cut off and redrilled.
Possible backrest heights:
RH [mm]
270
285
300
315
330
345
360
375
390
Backrest angle
If you want to change the backrest angle, then the complete backrest will
have to be replaced.
Possible backrest angles:
RW
74°
78°
82°
86°
90°
i
Changing the backrest angle also modifies the tipping point of the
wheelchair.
Tipping point of the wheelchair
The tipping point of the wheelchair can only be modified by fitting a new
backrest with a larger or smaller backrest angle. The seat depth can also be
adjusted by changing the hole position.
Replacing the Standard Light backrest cover
Difficulty:
Tools:
Ã
3 8 Ò
2
Remove push handles, if fitted, Chap. Back, ‹Replacing push handles›.
Remove bolts and , clothes guard or mudguard.
Open the Velcro® fastener on both sides.
Pull the backrest cover up and off and slip the new backrest cover over
the backrest tubes.
Close the Velcro® fasteners again on both sides.
Fit mudguard or clothes guard.
Fit push handles, if required.
1
à 7 Nm
à 7 Nm
à 7 Nm
2
3
1