KUSSMAUL PDS-100 User Manual

Summary of PDS-100

  • Page 1

    170 cherry ave., west sayville, new york 11796 phone: 800-346-0857 fax: 631-567-5826 e-mail: sales@kussmaul.Com www.Kussmaul.Com manual part #: m-kpds100 as of june 2013 power distribution system user’s manual model: pds-100 section page product overview........................................... 1 ...

  • Page 2: Pds-100

    170 cherry ave., west sayville, new york 11796 phone: 800-346-0857 fax: 631-567-5826 e-mail: sales@kussmaul.Com www.Kussmaul.Com +12v dc battery in/ parallel bus tie point ignition sense (+) terminals, 1/4” male fast-on battery input ok (green) circuit id # atc/ato fuse 20 amp max. Fuse ok led (gree...

  • Page 3

    170 cherry ave., west sayville, new york 11796 phone: 800-346-0857 fax: 631-567-5826 e-mail: sales@kussmaul.Com www.Kussmaul.Com i) general information the pds-100 provides emergency and public safety vehicle electronics installers with a convenient, efficient, safe and dependable method for adding ...

  • Page 4

    170 cherry ave., west sayville, new york 11796 phone: 800-346-0857 fax: 631-567-5826 e-mail: sales@kussmaul.Com www.Kussmaul.Com 3 iii) installation important notice: if not using the factory default programming (see page 9, setting to factory defaults), we recommend first programming the pds-100 on...

  • Page 5

    170 cherry ave., west sayville, new york 11796 phone: 800-346-0857 fax: 631-567-5826 e-mail: sales@kussmaul.Com www.Kussmaul.Com 4 battery wire size. Use 1/4” crimp ring terminals to make the wire connection to the +12v and ground input studs on single pds-100 installations and 5/16” crimp ring term...

  • Page 6

    170 cherry ave., west sayville, new york 11796 phone: 800-346-0857 fax: 631-567-5826 e-mail: sales@kussmaul.Com www.Kussmaul.Com figure 2: multiple unit wiring drawing table 1: recommended input power feed wire size - single unit max. Total load current amps wire size (awg) vs wire length (3% drop) ...

  • Page 7

    170 cherry ave., west sayville, new york 11796 phone: 800-346-0857 fax: 631-567-5826 e-mail: sales@kussmaul.Com www.Kussmaul.Com 6 v) load group power activation programming switch guide programming overview the pds-100 can be programmed to independently disconnect the 3 load groups based on various...

  • Page 8

    170 cherry ave., west sayville, new york 11796 phone: 800-346-0857 fax: 631-567-5826 e-mail: sales@kussmaul.Com www.Kussmaul.Com 7 the modes are as follows: 1) on with ignition, off with ignition: circuits will be energized anytime the ignition signal is ≥5 volts and de-energized if 2) on with ignit...

  • Page 9

    170 cherry ave., west sayville, new york 11796 phone: 800-346-0857 fax: 631-567-5826 e-mail: sales@kussmaul.Com www.Kussmaul.Com 8 lvd selection (mode 3) when the load group relay is set for mode 3, dip-switch positions 1 though 4 will set the desired low voltage disconnect and re-connect trip point...

  • Page 10

    170 cherry ave., west sayville, new york 11796 phone: 800-346-0857 fax: 631-567-5826 e-mail: sales@kussmaul.Com www.Kussmaul.Com 9 default factory setting: load group 1 mode = 1 on with ignition, off with ignition load group 2 mode = 2 on with ignition, off with timer timer = 2 minutes load group 3 ...

  • Page 11

    170 cherry ave., west sayville, new york 11796 phone: 800-346-0857 fax: 631-567-5826 e-mail: sales@kussmaul.Com www.Kussmaul.Com viii) troubleshooting problem/symptom possible cause solution no power to any of the six outputs 1) no or low ( 2) bad power input ground connection 3) defective unit. 1) ...

  • Page 12

    170 cherry ave., west sayville, new york 11796 phone: 800-346-0857 fax: 631-567-5826 e-mail: sales@kussmaul.Com www.Kussmaul.Com no output power from individual fuse output blown fuse determine reason for blown fuse, correct fault & replace fuse ix) warranty all products of kussmaul electronics comp...

  • Page 13

    170 cherry ave., west sayville, new york 11796 phone: 800-346-0857 fax: 631-567-5826 e-mail: sales@kussmaul.Com www.Kussmaul.Com x) dimensional drawing 12.