Kvaser BlackBird v2 User Manual - page 11
Kvaser BlackBird v2 User’s Guide
10 (18)
4
Appendices
In this section you will find technical information about the Kvaser BlackBird v2 and
its connectors.
4.1
Technical data
In Table 5 you will find the Kvaser BlackBird v2’s technical specifications.
CAN Channels
1 (CAN 2.0A and 2.0B active).
CAN Transceivers
TJA1051T (Compliant with ISO 11898-2)
CAN Controller
Built into the processor
CAN Bit Rate
40 kbit/s to 1 Mbit/s
Time stamp resolution
25 µs
Error Frame Detection
Yes
Error Frame Generation
Yes
PC interface
Supports USB 2.0 HiSpeed at 480 Mbit/s. Compatible with
USB 1.1 at 12 Mbit/s and with USB 3.0 at 480 Mbit/s.
Wireless communication
WLAN 802.11b/g/n, 2.4 GHz, (infrastructure and ad hoc-
mode)
Wireless security
WPA2 / WPA / WEP128 / WEP64
External power
Allowed operating voltage 9 - 40 V DC. Maximum input volt-
age 48 V DC.
Power consumption
Typical values are: 370 mA if powered from the USB (~5 V).
4.2 W for single channel powered from the CAN bus.
Hardware configuration
Done by software (Plug & Play).
Software requirements
Windows (XP with SP3 or later). (For other operating sys-
tems, see Kvaser web or contact Kvaser support.)
Dimensions
30 x 190 x 20 mm
Weight
165 g including cables and connectors.
Operating temperature
−40
◦
C to +70
◦
C
Storage temperature
−55
◦
C to +90
◦
C
Relative Humidity
0 % to 85 % (non-condensing.)
Table 5: Technical Specifications.
4.2
CAN connectors
The Kvaser BlackBird v2 using the 9-pin D-SUB connector (see Figure 3 on
Page 11) has the pinning described below (see Table 6 on Page 11).
Kvaser AB, Mölndal, Sweden — www.kvaser.com