LA Fitness DK900EAJ01AA Owner's Manual - page 16
15
2012/3/8Ver1.4+Ver1.1
4-4. During Program, the scrolling text will display:
4-4-1. Metric system『KMH』:
It will display『LEVEL』
、
『
RPM』
、
『
DIST』 and『WAT』for 1 seconds first,
then it will display the values for 10 seconds. After that, it will display
『
LEVEL』、『KMH』、『TIME』 and『CAL』for 1 second, then the values
for 10 seconds.
4-4-2. Imperial system『MLH』:
It will display『LEVEL』、『RPM』、『DIST』and『WAT』for 1 second first,
then it will display the values for 10 seconds. After that, it will display
『
LEVEL』、『MLH』、『TIME』and『CAL』 for 1 second, then the values
for 10 seconds.
4-5. When the program is finished, the scrolling text will display
4-5-1. Metric system『KMH』:
The scrolling text『EXERCISE TIME =』, then『HHMMSS= 0.00.00』
The scrolling text 『DISTANCE COVERED =』, then『KM= 0.0』
The scrolling text『AVERAGE SPEED =』, then『KMH= 0.0』
The scrolling text『CALORIES BURNT =』, then 『KCAL= 0.0』
The scrolling text『AVERAGE WATTS =』, then『WATTS= 0.0』
The scrolling text『AVERAGE METS =』, then『METS= 0.0』
4-5-2. Imperial system『MLH』:
The scrolling text『EXERCISE TIME =』, then『HHMMSS= 0.00.00』
The scrolling text『DISTANCE COVERED =』, then『ML= 0.0』
The scrolling text 『AVERAGE SPEED =』, then『MLH= 0.0』
The scrolling text『CALORIES BURNT =』, then『KCAL= 0.0』
The scrolling text『AVERAGE WATTS =』, then『WATTS= 0.0』
The scrolling text AVERAGE METS =』, then『METS= 0.0』
5.
HRC Mode:HRC Mode
5-1. Under Start/Ready status, press HRC and the Dot Matrix will display heart picture, and
the scrolling text will display『PRESS ENTER TO BEGIN PROFILE.』.
5-2. Press ENTER and the Dot Matrix will flash “60﹪”, the scrolling text will display
『
PRESS LEVEL UP/DOWN TO SELECT PROFILE.』. After that, you can press
LEVEL ▲ or LEVEL ▼ to choose the other PROFILE of HRC. There are totally 6
heart rate control modes including 60%, 65%, 70%, 75%, 80% and 85%.
5-3. The operation procedure instructions for 6 heart beat control modes as 60%, 65%,
70%, 75%, 80% and 85%:
When you set the value of heart rate, the Dot Matrix will be flash to display the value.
Then you can press ENTER to set age.
5-4. Procedures for setting age: