La Gard 8130 Installation Instructions Manual - page 13
Other manuals for 8130:
Installation Instructions, User Operating Instructions
Manual is about: ELECTRONIC ENTRY DEVICE
of
13
(P/N)762.128 Rev E • 08/15
© copyright 2009-2015
Kaba Mas LLC
page 11
The holes required to mount the knob need to be drilled 1.25" apart and must be centered over the spindle hole.
1. To install the Knob Assembly, remove the insert from the front of the knob.
2. Cut the spindle to a length of .820" (20.8mm) plus the door thickness (Figure 14).
NOTE: the spindle must be deburred.
3. Install the knob assembly using the two 8-32 X 5/16 phillips pan screws.
4. Install the lock (with the bolt extended) onto the spindle, placing it flush to the mounting surface. Refer to lock installation
instructions which are available at www.kaba-mas.com.
2666 KNOB ASSEMBLY
2666
Figure 14
DOOR
MOUNTING PLA
TE
Total Mounting Thickness = door thickness
+ mounting plate