MANUAL FOR USE AND MAINTENANCE
LSC 001 -UK- REV. 06
STARTING UP AND PROGRAMMING THE APPLIANCE
(Range S3 - Seletron model)
FOLLOW THE INSTRUCTIONS BELOW REFERRING TO THE PARTS LIST ON PAGES 27/34.
BOILER WATER FILLING
a) Turn on the water supply tap, which was fitted during the system pre-arrangement phase (2 - Fig.1 - page
b) Make sure that the mains water pressure (more or less 4 bar) is shown on the motor-driven pump
pressure gauge (17).
c) Push the knob on the manual filling valve on the appliance (1) downwards until the boiler level indicator
is halfway (2).
SWITCHING ON THE APPLIANCE ELECTRICALLY
a) Turn on the main switch (1 -Fig. 1 - page 6), then turn on the appliance switch (3) moving the lever to
ON position and making sure that the display (33) switches on.
NOTE. According to the amount of water manually filled, it is possible to program the automatic
filler system to operate when the switch (3) is turned on and until the correct water level in the
boiler for standard operation has been reached.
HEATING PHASE AND PREPARATION OF THE APPLIANCE FOR OPERATION
a) Attach the filter holders (11) to the delivery groups (16).
b) Open the steam delivery knobs (5) (by turning them anticlockwise) and leave them open; then move
the steam wands (8) over the grid (10).
c) Wait for steam to come out of the wands (8) (about 15 / 20 minutes) and then close the steam delivery
knobs (5) (by turning them clockwise).
d) Wait for the appliance to reach the operating temperature, which was preset during installation. The
setting in °
C can be visualized on the display (33) on the control panel, or alternatively on the pressure
gauge (4) (pressure 1 bar) on the appliance.
NOTE. The operating temperature is the temperature of the boiler during standard operation.
e) The appliance is ready for use.
The appliance is supplied with its basic settings already programmed. These are:
• Day of the week
• Date (day, month, year)