La Spaziale S1 Mini Vivaldi Instruction Manual - page 11
INSTRUCTION MANUAL
LSC 014 -UK- REV. 01
11
NOTE.
Access to this programming function is only possible when the delivery group temperature set is
programmed to the minimum value (91°C) or the maximum value (97°C).
• Switch off the appliance by pressing the button
ON/OFF (27), the green control light (22) will go from
lit to flashing (machine on Stand-by).
• Press and hold down the two-cup button (25) for about 3 seconds; the control lights 17 and 18 will switch
on to indicate that the programming phase has been activated to reduce the minimum temperature or
increase the maximum temperature.
• Each time that the steam delivery button (26) is pressed, the control lights 19, 20 and 21 will switch on
in succession; each control light indicates an increase of one degree centigrade compared to the set
temperature, if the starting point was a temperature setting of
97°C. Each time that the one-cup button
(24) is pressed, the control lights 16, 15 and 14 will switch on; each of these control lights indicates
a decrease of one degree centigrade compared to the set temperature, if the starting point was a
temperature setting of
91°C. For example, if the set temperature is 97°C and the control lights 19 and
20 are switched on, the new set temperature will be 97 + 2 =
99°C.
The operating temperature of the appliance is modified exclusively to improve the result in the cup according
to the type of coffee blend used.
3.3 PROGRAMMING THE DOSES
1. While the appliance is operating (control light 22 lit), press and hold down the button
ON/OFF (27) for
about 3 seconds; the power control light (22) and the set temperature control light will start to flash.
2. Fill the filter holder (11) with the 1-cup coffee filter (using the coffee doser provided), taking care not to
leave any coffee powder on the top edge of the filter holder (11), and press it down using the special
coffee tamper provided.
3. Attach the filter holder (11) to the group (10), placing a cup below the filter holder.
4. Press the 1-cup button (24) to start delivery and the control lights 14-15-16 will switch on to indicate that
the dose for one cup of coffee is being programmed.
5. When the amount of coffee in the cup has reached the required dose, press again the button (24) again
to stop delivery.
6. The display will automatically show the main programming menu again.
7. Fill the filter holder (11) with the 2-cup coffee filter (using the coffee doser provided), taking care not to
leave any coffee powder on the top edge of the filter holder (11), and press it down using the special
coffee tamper provided.
8. Attach the filter holder (11) to the group (10), placing two cups below the filter holder.
9. Press the 2-cup button (25) to start delivery and the control lights 17-18-19 will switch on to indicate that
the dose for two cups of coffee is being programmed.
10. When the amount of coffee in the cup has reached the required dose, press the button (25) again to
stop delivery.
11. The display will show the main programming menu again.
NOTE.
To quit the programming function, press the button ON/OFF (27).