Lab.gruppen PLM Series Quick Start Manual - 6. Quick Start Tutorial
PLM Series Quick Start and Field Reference Guide rev 1.0.6
6. Quick Start Tutorial
17
scale
until 0.00 dB is showing in the blue box at the top of the fader.
Close the control panel
by tapping
on the Return button.
The block diagram should now indicate that the 3-way crossover is fed from Input 1 only, at zero level.
18.
Now note the small square block towards the bottom of the pane labeled Post EQ. This currently indicates
that the Auxiliary output channel (which will be output 4) is fed from the main crossover signal path. As
Analog Input 2 is being used for the subwoofer input,
tap on the Post EQ block
. This will change the
routing of the Auxiliary channel to receive its input directly from the Input Mixer and not post-EQ.
Tap on the lower Input 1 block
19.
(still in Module A’s pane) to open the Input mixer control panel for the
Aux channel.
Move Input 2’s fader to the 0.00 dB position and tap on the Input 1 On/Off button
(at
the bottom of the fader) so that it turns red. The block diagram will now show that the Auxiliary channel is
fed from Input 2 only, at unity gain.
Tap the Return button
to close the Aux Input Mixer window.
Note that Module B’s processing is not required in this configuration.
20.
Open Module B’s input mixer in
the same way as the previous steps
, and make sure that both Input 1 and Input 2 are selected OFF.
Tap any of the four magnifying glass symbols
21.
at the right-hand edge of Module A’s pane to open the
Output Configuration control panel. It is possible to reassign each of the four Module outputs to any of
the power output channels. To ensure that the PLM is set up in accordance with your original channel
allocation,
check that the Output Configuration control panel looks like this:
Figure 6.4: Output configuration page
If the output assignments are not as shown,
22.
tap the Clear All Assignments button
(“split arrows”) and
tap Yes to the warning dialog box. Then tap the numeric buttons
to set the assignments as shown
in the screenshot above. Tap the return key to close the control panel and return to the I/O Config page.
The following settings in the left-hand pane should be made automatically by default:
23.
Digital Clock: Internal – 96 kHz
▸
Input Configuration: Auto: Auto; Type: Analog; Offset/Headroom: 26 dBu
▸
Dante Configuration: Dante Disabled
▸