Labgear FV400 Instruction Manual - page 7
Made in China
Serial No.:
VCR O O
TV
SERVICE
100-240V~
50/60Hz
Coaxial
Digital
Audio
RISK OF ELECTRIC SHOCK
DO NOT OPEN COVER
CAUTION
DIGITAL TERRESTRIAL RECEIVER
POWER SUPPLY: 100-240V~ 50/60Hz
MAX POWER CONSUMPTION: 10WATTS
FV400
ANT IN
RF OUT
RF IN
TV OUT
5
Front Panel and Rear Panel Illustration
1. Front panel
1 TV OUT: This socket will transmit the modulated A/V signal to the ANT IN socket of your TV.
2 RF IN: This socket connects to the RF OUT socket or your external aerial if you want to loop
through the external analog/digital RF signal from ANT IN to TV OUT socket. But please make
sure there is no frequency conflict between this signal and internal RF modulated A/V signal,
otherwise your analog TV will not receive the modulated A/V signal.
3 ANT IN: This socket connects to your external aerial.
4 RF OUT: This socket will bypass the RF signal to either your TV or another video system.
5 COAXIAL: This socket connects to a coaxial socket on your surround sound system.
6 VCR SCART: This socket connects to either a DVD or other video system.
7 TV SCART: This socket connects to your TV.
8 RS-232 PORT: This socket is only used for software upgrade.
9 MAINS CABLE: This is used to connect to your main power supply.
1 POWER BUTTON: Used to switch the set top box on and off.
2 LED DISPLAY: Used to display the time or channel information
3 CHANNEL UP/DOWN: Used to change channels without using the remote control.
4 REMOTE CONTROL SENSOR: Used to receive the signal from the remote control.
5 STANDBY INDICATOR: Used to visually show power state of the set top box, the green
LED will be lit if the set top box is turned on and the red LED will be lit if the set top box
is in standby mode.
3
5
4