Labomed CxL User Manual - Initial Set Up

1

2

3

Objectives

Observation Head

Eyepieces

Objectives are factory set. Objectives are par-centered and par-

focalised during assembly phase.

All objectives have been secured for a tight fit to prevent them from 

coming loose during transit. To remove an objective, rotate it 

counterclockwise while holding it with a rubber sheet, etc. to avoid any 

slippage.

Insert  the  eyepieces  into  the  ocular  tube  of  Observation  Head  using 

following procedure:

1.

Remove the protective caps from the observation tube.

2.

Insert  10x  eyepieces  into  the  ocular  sleeve  and  tighten 

the  clamping  screw  (1)  using  allen  wrench  1.2mm.  See 

figure 10.

Install the observation head using following procedure:

1. Using allen wrench 3mm, loosen the Head Locking Screw (1) 

and remove the dust cover cap provided in dovetail cavity as 

well as on observation head dovetail.

2. Mount the Observation Head by engaging the dovetail provided 

at the bottom of the head into the dovetail cavity provided in the 

microscopes arm.

3. Tighten the Head Locking Screw (1) after positioning the 

Observation Head as desired.

Fig. 7

Fig. 8

Fig. 9

1

Fig. 10

1

INITIAL SET UP

CxL

10

14