Lagoon 450 User Manual - page 25
2
LAGOON 450
HULL / DECK
HULL / DECK
23
2.9 Gangway (optional extra)
The boat may optionally be fitted with a foldable carbon gangway.
Remove, store and stow the gangway when sailing.
2.10 Davits (optional extra)
The boat may optionally be fitted with manual winch and davits.
An electric winch can be chosen as an option.
The winch is automatically turned on when the general cut out on
board is set to ON.
If it does not function properly, check its fuse located in the electrical
room, in the starboard aft passageway.
z
INSTALLING A TENDER ONTO THE DAVITS
After having taken away everything from the tender and removed the
cap:
- Fix the davit rope hooks to the front and rear parts of the tender.
- Lock the jammers located on the davits.
- Take the front part of the tender half way up using the cockpit
winch.
- Do the same for the rear part.
- Alternatively lift up the front part then the rear part of the tender until
it touches the davits.
z
LAUNCHING A TENDER FROM THE DAVITS
Put the water drain plug back into position in the tender.
Make fast the tender.
- Check that the jammers located on the davits are locked.
- Run the davits pennant attached to the rear of the tender around the
winch (spin at least three times around it).
- Open the jammer and slack the pennant half-way.
- Lock the jammer.
- Do the same for the front part.
- Let the tender go down alternately front and rear until it touches
water.
When sailing, remove the tender engine and store it on board.
Moor the tender considering the sea state and the route.
Put in the tender the security equipment in conformity with the
registration country of the boat.
WARNING
The davits are designed to support a maximum
load of 250 kg and a tender which is maximum 3,80
metres long.
WARNING
Do not use the gangway as a diving board.