Lakeland 16147 Instruction Booklet - page 19
36
37
Problem
Possible Cause
Solution
11. Bread does not slice well
and is sticky.
•Sliced whilst hot.
•Wrong knife used.
•Allow bread to cool for at
least 30 minutes to allow
steam to escape before
slicing.
•Use a good quality bread
knife.
Crust colour and thickness
12. Dark crust colour,
too thick.
•DARK crust colour selected.
•Use MEDIUM or LIGHT
setting next time.
13. Burnt loaf.
•Bread maker
malfunctioning.
•Refer to customer care
section.
14. Crust too light.
•Bread not baked long
enough.
•LIGHT crust colour selected.
•Carry out a BAKE cycle to
darken the crust.
•Choose DARK or MEDIUM
crust colour next time.
Bread pan problems
15. Kneading paddle cannot
be removed from pan.
•You must add enough
water to cover the
kneading paddle and then
leave to soak for
10 minutes.
•Twist kneading paddle
slightly after soaking to
loosen.
16.Breadstickstopan/
difficult to shake out.
•Lightly wipe the inside of
the bread pan with
vegetable oil.
Bread maker
17. Bread maker not
operating/kneading
paddle not moving.
•Bread maker not switched
on.
•Bread pan not correctly
located.
•Time delay selected.
•Check the product is
turned on.
•Check pan is locked in
place correctly.
•Bread maker will not start
until start time is reached.
Problem
Possible Cause
Solution
18. Ingredients not mixed.
•Did not start bread maker.
•Forgot to put kneading
paddle in bread pan.
•After selecting programme,
presstheSTART/STOP
button to start machine.
•Always make sure kneading
paddle in positioned
correctly on drive shaft in
bottom of bread pan
before adding ingredients.
19. Burning odour noted
on operation.
•Ingredients spilled inside
baking chamber.
•Take care when adding
ingredients to bread pan –
if ingredients spill into
chamber burning can occur.
20. Display screen shows
“H HH” and machine
beeps continuously.
•Temperature inside bread
maker is too high –
machine still hot after the
previous baking procedure.
•PressSTART/STOPbutton,
open lid and allow machine
to cool down for 10 – 20
minutes.
21. Display screen shows
“L LL” and machine
beeps continuously.
•Temperature inside bread
maker is too low.
•PressSTART/STOPbutton,
open lid and allow machine
to return to room
temperature for
10 – 20 minutes.
22. Display screen shows
“E EO” or “E E1”.
•Temperature sensor is
faulty.
•Contact Lakeland Customer
Services for further
information.