Lami Corporation Lotus-13 LK Instrustion Manual - page 13
12
① Push COLD button to stop roller heating when you tidy up the machine.
② Turn off the power switch after auto stop of rollers and fans and losing of its heat.
And unplug the power plug from outlet.
③ Put the machine into box when keeping.
If you have no box, cover clothe over the machine to prevent from dust or direct sunlight.
Tidy up the machine
Do test lamination using same paper if possible.
Do actual lamination after confirmation of it.
① Insert lamination material into the laminator from sealing surface.
② Take care of handling of after lamination material because it has heating.
Wait automatic rejection. It may cause winkle or waving to pull it compulsorily.
③ Put after lamination material on flat place until it lose its heat.
It may cause curved shape if you bend lamination material with heat.
Lamination of film
① Make sure that paper is suitable for lamination referring to P11.
② Prepare lamination film that matches the size of paper.
If there is a large difference in the size of paper and lamination film,
please use it after referring P11.
③ Put paper into lamination film.
Preparatio of paper and film
Numerical value will be fluctuates according to paper type and absorbability of ink.
We do not guarantee numerical value. These are just for your reference.
thick:200 g/ ㎡(thick paper)
140℃
2
Middle:120 g/ ㎡(catalogue)
140℃
4~5
Thin:80 g/ ㎡(copy paper)
120℃
3~4
250μ
Thick:200 g/ ㎡(thick paper)
140℃
3
Middle:120 g/ ㎡(catalogue)
130℃
4~5
Thin:80 g/ ㎡(copy paper)
110℃
3~4
200μ
Thick:200 g/ ㎡(thick paper)
120℃
2~4
Middle:120 g/ ㎡(catalogue)
110℃
3~5
Thin:80 g/ ㎡(copy paper)
100℃
5~6
150μ
Thick:200 g/ ㎡(thick paper)
120℃
3~5
Middle:120 g/ ㎡(catalogue)
100℃
6~7
Thin:80 g/ ㎡(copy paper)
100℃
6~7
100μ
Velocity
Temperature
Paper thickness
Film thickness
① Install the machine on suitable place and turn on the power switch which is back of it.
② Adjust adequate temperature for lamination material.
③ Make sure reach of set temperature and adjust velocity.
Preparation of the machine
Please refer to procedure below when laminating.
Procedure of lamination processing
Lamination processing