Lami Corporation Lotus-13 LK Instrustion Manual - page 16
15
●In case you use heater or projector or electric wire reel around.
●In case of overloaded.
●In case motor has strange noise.
Pull the fuse box with a flathead screwdriver or the like.
Please check fuse of fuse box tip is snapped or not.
If fuse wire is snapped, replace it and turn on the machine again.
Back of machine
Fuse Box
Fuse
Preliminery Fuse
Please confirm visually
this part of wire is snapped or not.
The snapping of Fuse
●Plugging in power plug, confirmation of power switch.
This machine is for AC230V. Please check power plug is properly connected.
Please check power switch is on. If the power code has crack or snap, you need to replace it.
Contact our dealers or us.
●Confirmation of fuse.
There is a fuse box in the back of the body. Please check if fuse is disconnected or not.
If it is disconnected replace it of same specification.
If same problems continue to occur, contact to our dealers or us.
In case that you can not turn on the machine, or it does not work
Before you think machine failure
If you are in former situation, use another power source.
Use the machine without electric wire reel.
There is a possibility that motor protection function works.
Turn off the machine and wait 10 seconds or more and turn on the machine again.
If motor has strange noise, gear is damaged or screw is loosen.
Please contact to our dealers or us.