Lami Corporation Lotus-13 LK Instrustion Manual - page 6
5
① Be sure to confirm temperature decrease and machine status for you to turn off the power.
② Turn off the machine.
③ Unplug the power plug from the outlet and remove the power code from the body.
In the case of moving
④ Move the machine with holding firmly by both hands.
※After lamination the machine has heating in some case.
Please confirm it and move the machine.
⑤ Install the machine in safe location referring to above articles.
In the case of strage
④ ※Keep the machine in dedicated box after the temperature of machine has
completely normal temperature.
※If you do not have a box for this machine, cover the machine and keep it to prevent
from dust with rollers. Be sure to cover the machine after it has adequate temperature.
Caution(moving and strage)
500mm
500mm
270mm
540mm
100mm
100mm
ex:A3 size
lamination
Install the machine on a place like below.
●Horizontal and suitable place
It causes harm of paper feeding or unexpected accidents when you use the machine
in inclined state, unstable state. Install the machine on a horizontal and stable place.
●Place with special power outlet
Do not use any power source which is not described in this document.
Use power source only rated voltage described in this document.
●Well ventilated place without moisture.
It may be a cause of leakage or failure for the machine to install in humid place.
In addition,be sure not to install the machine outdoor or place with direct sunlight or
with direct air of air conditioner.
Temperature:10~35℃
Humidity:20~60%
※In some case, even in mentioned conditions, you can not laminate adequately
if condition of film or paper is not suitable for lamination.
●Operability
Operability is improved more if you have enough space in normal use or in maintenance.
Suitable place for installment