2 b rew e xpress ™ installat ion guide model no. Be-112 by for more information see our instructional video online at wwww.Brewexpress.Com..
Cont en ts 1. Safety 1 - 2 2. Getting started 3 3. Hardware/tools 4 4. Specification and requirements 5 5. Location (area of installation) 6 6. Water installation 7 7. Power installation 8 8. Brewer installation 9 - 12 9. Testing 13 10. Troubleshooting 14.
Important: read and follow instructions carefully before installing your brew express™ in-the-wall coffee system. Wire the brew express™ to a gfci ground protected source. This can be accomplished by: (a). Wiring the unit directly to a string of outlets that are protected by a gfci outlet. Or (b). W...
3 4 hardware/tools hardware brew express™ comes supplied with the following items to ensure a successful installation. Check to be certain all items have been included with your brewer. • (1) brewer (with short water line attached to connect with incoming water line) • (1) rough-in-box • (1) carafe ...
Important: read and follow instructions carefully before installing your brew express™ in-the-wall coffee system. For best results it is advised that you hire a qualified professional. 1. Overall dimensions (finished unit with rough-in-box) approximately 12.5” x 12.5” (see below). 2. Dimensions for ...
Always turn off water supply at source. It is strongly advised you consult a qualified professional plumber when attempting to install brew express™ in-the-wall coffee system. It is important to make sure there are no conflicts or obstructions in the wall cavity such as plumbing or electrical wires....
Installation of rough-in-box 1. Locate wall studs within the desired location of wall. Using the template provided, place template on wall as shown. Slots in template should be flush with left or right side of wall stud edge. The slots in the template designate the area to be cut. The bottom of temp...
5. Bring 1/4” water supply line from source (see page 6) to cut opening as shown in figure 2. (page 9). Bring water line through grommet in rough-in-box (see supply detail). Carefully slide rough-in-box as shown into cut opening while gently pulling water supply line through grommet hole in rough-in...
13 14 testing troubleshooting testing once brew express™ has been installed into the rough-in-box it must be tested to ensure proper operation. 1. Turn on electrical power. Check to see if display panel is illuminated, the display panel is lit when electrical supply has been properly connected. If t...
16 troubleshooting 15 troubleshooting troubleshooting water overflow from brew basket • paper filter is not high enough and grounds are flowing over and plugging brew basket (use higher filter) we suggest purchasing bunn brand filters. Excessive steam • inlet water line connected to hot water supply...
Printed in china. Be112-ig/02_07 r-1 © lance larkin 2005 www.Brewexpress.Com.
