Lance-Larkin BREW EXPRESS BE-112 Installation Manual - page 8
5. Bring 1/4” water supply line from source (See page 6)
to cut opening as shown in Figure 2. (page 9).
Bring water line through grommet in rough-in-box
(See Supply Detail). Carefully slide rough-In-box as
shown into cut opening while gently pulling water supply line
through grommet hole in rough-in-box pulling through excess
(approx. 18”). Secure rough-in-box to wall stud with sheet rock
screws. PURGE WATER LINE by running water through line to
clean any possible debris. Cut water line to length (approx. 3”)
inside rough-in-box and attach male quick connector.
(See Male Connector Detail) and Figure 4.
IMPORTANT:
Water line to brewer must be flushed and a filter installed.
Should debris clog brewer system ALL WARRANTIES VOID.
4. Place rough-in-box on a towel or cardboard to protect
counter surface. Bring power supply wire from source
to cut opening as previously shown in Figure 2. Minimum
12-2 wire required. Be sure to have an additional length of
approximately 18” recommended at rough-in-box opening
for installation of box. Remove power panel cover. Install
strain relief (not supplied) in hole. Run power supply wire
through strain relief and secure power supply wire
(See Supply Detail, page 10). Connect power supply wires
to power panel supply wires and secure with wire nuts
(See Wiring Detail, page 10). Connect green wire to
green wire, black to black and white to white. Carefully
reinstall power panel cover. Be certain not to damage
wires or insulation. See Figure 3.
11
12
BrEwEr INSTALLATION
BrEwEr INSTALLATION
6. After sheet rock screws are in place, gently bend appropriate
tabs (long or short depending on wall thickness such as tile
or granite) as shown on all other areas to finish securing
rough-in box to wall. Use pliers (if needed) to bend/crimp
tabs firmly to wall. Gently slide excess water line back through
grommet into wall cavity leaving top of connector a maximum of
3” above bottom of rough-in box. See Figure 5. and Figure 6.
Installation of Brewer
7. Quick connector is valved at rough-in-box so water can be
turned on prior to connection to coffee maker. Place unit on
a towel or cardboard to protect counter surface. Place
BREW EXPRESS™ directly in front of rough-in box. Use quick
connector to connect water supply line from BREW EXPRESS™
to water supply line from rough-in-box (See Quick Connect Detail).
Snap connectors together firmly. Turn on water, check for leaks prior
to final installation of BREW EXPRESS™. If leaking, turn off water,
tighten connections or reinstall quick connector. Turn water on
and check again. See Figure 7.
8. Gently slide the BREW EXPRESS™ into the rough-in-box.
Be careful not to damage water supply lines. A firm fit will
connect power from rough-in-box to the BREW EXPRESS™.
Use four mounting screws to secure BREW EXPRESS™
inside rough-in-box. Be careful not to damage counter top.
NOTE: Refer to OPERATION GUIDE for further instructions
before using BREW EXPRESS™.
WARNING:
Do not caulk or grout brewer to wall.
3" max
Figure 6
Quick Connect Detail
Figure 7
Figure 8
Figure 5
Supply Detail
Wiring Detail
Male Connector Detail
All electrical wires and connections MUST be tucked
neatly and completely inside POWER PANEL COVER
without any exposed wiring inside rough-in box. It is
advised you contact a qualified electrician.
Figure 4