Lance-Larkin BREW EXPRESS BE-112 Installation Manual - page 7
Installation of Rough-In-Box
1. Locate wall studs within the desired location of wall.
Using the template provided, Place template on wall as
shown. Slots in template should be flush with left or right
side of wall stud edge. The slots in the template designate
the area to be cut. The bottom of template reflects the
bottom of the unit. See figure 1.
2. Use a utility knife to carefully cut inside the penciled
outline area. Start with the stud side and work outward.
DO NOT USE A SAW. Remove sheet rock piece exposing
wall cavity. Bring water and power supply lines from source
to this location. See Figure 2.
3. Completely seal all gaps between counter and wall with
silicone caulk. This prevents water from going behind the
cabinet if there is a water leak.
Figure 3
Figure 1
9
10
BrEwEr INSTALLATION
BrEwEr INSTALLATION
IMPORTANT:
If installing Unit PRIOR to cabinets, it is strongly advised to consult with cabinet maker and build-
ing contractor for exact height of counter top due to the various thicknesses of counter tops (tile
laminate, granite, etc). For best results cut hole and install unit AFTER cabinets are installed.
A. Installing BREW EXPRESS™ on Counter
It is best to install the unit so the bottom edge is just off the
counter top. In an existing home, this may require part of the
back splash to be removed. Use template provided to
determine the location to be cut out for rough-in-box.
B. Installing BREW EXPRESS™ with Full Back Splash
Use template provided to determine the location to be cut
out for rough-in-box. Ensure fit is correct by first placing
rough-in-box in cut out hole. Remove rough-in-box. Finish
installation of full height back splash to cut opening. If full
height back splash is granite or tile, it is recommended to
cut opening and install rough-in-box after surface is complete.
IMPORTANT: DO NOT COMPLETE INSTALLATION OF
ROUGH-IN-BOX BEFORE BACK SPLASH.
C. Installing BREW EXPRESS™ above Back Splash
If you prefer a continuous back splash, the unit can be installed
above the back splash. Use template provided to find best fit.
IMPORTANT: WHEN INSTALLING THE UNIT ABOVE BACK
SPLASH, BE CERTAIN THERE IS SUFFICIENT ROOM BELOW
THE CABINETS.
Caulk gap
Figure 2