Landmann Atracto Assembly And Operating Manual - page 10
12
1244202
Igniting the burners
Danger: Gas deflagration on ignition
If unburned gas accumulates, deflagration can
occur when igniting.
Possible consequences:
• Severe injury to persons or damage to prop-
erty
Safety measures:
• When actuating the Piezo igniter (A) do not
bend over the burners.
• Never re-ignite immediately if the flame goes
out, instead:
– Turn the flame regulators (2 x B and C) to
"Off" to interrupt the supply of gas.
– Wait for 3 minutes to ensure that any accu-
mulated gas has dissipated.
– Then re-ignite the burners.
The first time you use the barbecue, heat for some
20 minutes without food so that the food-safe coat-
ing is hardened (as with any oven).
Igniting the burner on the grill unit (34)
1. Open the lid on the grill unit (3).
Keep a safe distance from the burners (34) during
the next few steps.
2. Press and turn the flame regulator (B) anti-clock-
wise to HIGH ("large flame"). Hold it in this posi-
tion.
3. Press the Piezo igniter (A), if necessary repeatedly,
until the gas is ignited.
A clicking sound indicates that the Piezo igniter is
lighting.
If the gas fails to ignite within 5 seconds, turn the
flame regulators (2 x B) to "Off" position, wait for
3 minutes and repeat steps 2 and 3.
To ignite the other burner press and turn the cor-
responding flame regulator (B) anti-clockwise to
HIGH ("large flame"). Hold it in this position for
5 seconds.
The gas in the burner is ignited by the flame of the
adjacent burner.
4. Close the lid on the grill unit (3) and allow the bar-
becue to heat up at full power.
5. When the barbecue is heated up, turn the flame
Operation
Starting up the barbecue
1. Check to ensure that ....
– there are not, and will not be, any flammable
materials or substances nearby. Minimum dis-
tance to flammable materials or substances: 2
m above and 1 m to the side; distance to less
flammable materials or substances: min 0.25 m.
– the barbecue is positioned firmly on a suffi-
ciently large surface area. It must not be moved
during operation.
– the barbecue is fully assembled and has no
apparent faults.
2. Position the aluminium drip pan on the shelf (31).
31
Inserting the aluminium drip tray
3. Open the lid of the grill unit, this prevents gas
building up underneath it.
4. Open the cylinder valve (G2 to 6 o'clock position).
5. Check to ensure that the gas system is sealed. Oth-
erwise, shut-off the cylinder valve immediately
(turn the operating lever (G2) to 3 o'clock posi-
tion).