Landmann Atracto Assembly And Operating Manual - page 8
10
1244202
Assembly
Here are a few tips to help you assemble your barbe-
cue quickly and successfully:
• Check that no parts are missing by placing all of
the individual parts on an empty table (subject to
minor technical changes).
• If, despite careful factory checks, a component
should be missing, please contact our customer
service department (see last page). We will imme-
diately attend to your request.
• To assemble the barbecue you only need a
medium-size screwdriver as well as an 7, 10 and 13
mm open ended spanner.
• Only use tools that are intact and suitable for the
job at hand. Worn or unsuitable tools will not
allow you to tighten the bolts sufficiently, but
will damage them to the extent that they can no
longer be turned.
• Always fit all connecting elements (screws, nuts,
bolts, etc.) as shown in the illustrations. If you
misplace a connecting element, replace it with
an appropriate part. Only by doing this can you
ensure that the construction is strong and safe.
• Be sure to follow the instructions in the specified
order!
• Even if you are not experienced at DIY, assembly
does not generally take longer than one hour.
•
The illustrations showing the assembly steps are
at the end of this manual.
Connecting and disconnecting
the gas cylinder
Important information concerning the gas
connection
Danger: Gas ignition
Liquid gas is highly flammable and explosive.
Possible consequences:
• Serious personal injury or damage to property
if escaping gas ignites in an environment in
which it is not controlled.
Safety measures:
• Select a suitable area in which to set up the
barbecue. Make sure that ...
– there are not, and will not be, any flam-
mable materials or substances nearby. The
minimum distance to flammable materi-
als or substances is 2 m above and 1 m to
the side of the barbecue; the distance to
less flammable materials or substances is at
least 0.25 m.
– the barbecue is positioned firmly on a suf-
ficiently large surface area. It must not be
moved during operation.
– Position the gas cylinder next to the barbe-
cue.
– Never lay the gas cylinder on its side or
place it on the lower shelf.
– The gas hose must not be kinked or under
tension.
• When connecting the gas cylinder ensure that
there are no sources of ignition within a 5 m
radius.
• Take special care not to light any naked flames,
do not smoke or switch on electric appliances
(devices, lights, door bells), etc (spark-over
possible).
If necessary, make sure you replace the gas
hose to comply with national requirements.