Lanier R/C MARINER 40 MK II ARF Assembly Manual - page 11
Lanier - SHRIKE 40 - Instructions
Page 11
Copyright 1998 - Lanier R/C
MATERIAL LIST
FUSELAGE
1
(1) - bagged parts (laser cut Fl,F2 formers, sheer webs)
2
(2) - sheet 1 (laser cut fuselage sides FSlA)
3
(1) - sheet 2 (laser cut fuselage sides FS1B and formers)
4
(2) - 3/32" x 3 x 36" balsa sheet (top, bottom fuse, and wing sheeting)
5
(2) - 3/8" sq. x 36" balsa (stab leading, trailing edge and ends)
6
(1) - 1/2" x 36" tri-stock (front reinforcement, fin reinforcement)
7
(1) - 1/4"sq. x 36" spruce (servo rails)
8
(1) - 3/8" x 3" x 12" block (lower front block, upper front block)
9
(1) - 1/8" x 1/2" x 1-1/2" spruce (front nose skid)
10 (1) - 1/8" dia. x 2" dowel (hatch hold down)
WING
1. (2) sheet 3 (laser cut Rl, R5, and hatch parts)
2. (2) sheet 4 (laser cut R2, R3, and misc)
3. (1) 3/8” sq. x 24” hardwood (front spar)
4. (1) 3/8" sq. x 42" hardwood (rear spar)
5. (2) 3/8” sq. x 36” (leading edge)
6. (1) 1/4" sq. x 42" (trailing edge)
7. (5) 3/32" x 3" x 36" (leading edge, center sheet)
8. (4) 3/32" x 1-1/2" x 24" (trailing edge sheet)
9. (2) 3/32"x 3/8" x 24" (rib capping)
10. (1) 1/2" x 1-1/2 " x 12" (wing tip block)
11. (2) 3/16" x 2" x 24 " (tail fin )
12. (2) 7/16" x 2" x 16" tapered trailing edge stock (ailerons)
13. (1) 3/8" x 2-1/4" x 12" tapered trailing edge stock (elevator)
MISC.
1.
(1) - 1/2" x 16" (abs plastic skid cover)
2. (1) - 1/2" x 16" (double sticky sided foam tape)
3. (1) - 6" length of wire