Lanier R/C MARINER 40 MK II ARF Assembly Manual - page 12
Lanier - SHRIKE 40 - Instructions
Page 12
Copyright 1998 - Lanier R/C
HARDWARE AND MATERIAL LIST FOR SHRIKE 40
GENERAL
1
4-5 channel radio with 3-4 servos
2
Recommended engine - standard sport .40 (if larger than a .40, nose will have to be
lengthened to suit)
3
Muffler - to suit engine size
4
fuel tank - 8 oz. Sullivan SS-8
5
propeller - suitable size to fit engine
6
fuel line - Dubro no. 197
7
2-1/2" Tru-Turn spinner
8
covering, paint and trim - your choice
FUSELAGE
1
Engine mount - Hayes KM-40
2
Mounting bolt set - Dubro no. 129
3
Mounting bolt set - Dubro no. 127
4
Throttle pushrod - Dubro no. 108 Kwik-link with rod and Dubro no. 121 Ez-connector.
5
Elevator and ailerons pushrods (3) threaded 4-40 rods Dubro no. 144, (3) 4-40 Kwik-
links Dubro no. 304.
6
Hinges - Kwik Hinge - Dubro no. 537 (aileron and elevator)
7
Aileron Link Set - Goldberg no. 402
8
Aileron Horns - Dubro no. 107 (2 pair)
9
Hatch mount - Dubro no. 571 ½” 4-40 screw, #135 4-40 blind nut, and #323 #4 flat
washer.
10 Wing reinforcement - 2-1/2” Nylon tape - Goldberg #451
MISC.
1. Masking tape
2. Straight pins
3. Sandpaper - 80, 120 , and 220 grit.
4. Ex-acto knife with no. 11 blade
5. CA glue - thin and thick or white glue
6. Zap New Formula 560 Canopy Glue
7. Wax paper
8. Straight edge