©2007 copyright. Lantronix is a registered trademark, and securelinx is a trademark of lantronix, inc. All rights reserved. 900-416 rev. C 10/07 management appliance quick start guide securelinx management appliance (slm).
Slm quick start guide contents overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2 what’s in the box . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ....
Installing the slm installation includes setting the slm up in a rack and making serial console port (for initial setup only), network, and power connections. To install the slm: 1. Mount the unit in a 19-inch rack. Warning: be careful not to block the air vents on the front and back of the unit. If...
Configuring network settings network port 1 defaults to a dhcp-assigned ip address. If you want to assign a different ip address, it must be within a valid range, unique to your network, and with the same subnet mask as your workstation. To configure the slm, you need the following information: ip a...
Configuring network settings continued… 4. Enter the following information at the prompts: note: to accept a default or to skip an entry that is not required, press enter.We recommend that while you are logged in, you change the default password to prevent access by unauthorized personnel. Configure...
Configuring network settings continued… using the web interface once the slm has an ip address, you can use the web interface to configure required settings. To log in to the web interface: 1. Open a web browser (netscape navigator 6.X and later or internet explorer 5.5 and later with javascript ena...
Configuring network settings continued… obtain from dhcp: acquires ip address, subnet mask, and gateway from the dhcp server. (the dhcp server may provide the gateway, depending on its setup.) this is the default setting for network port 1. If you select this option, skip to step 3. Obtain from boot...
Configuring network settings continued… to set the local date, time, and time zone: 1. On the menu, click configuration➔services➔ date & time. The following page opens: 2. Specify the current date, time, and time zone, or select enable ntp to synchronize with an ntp server on your network. To change...
