Larsen & Brusgaard VISO User Manual - To Leave The Setup Area

0

1

General note:

The VISO goes out of ACCESS and back to the Main Window if no button has been 

pressed within 1 sec.

ALL functions (except Power ON) can be performed ONLY when the VISO is in ACCESS mode.

To leave the Setup Area

Wait until the display times out, or press     repeatedly until the Padlock window 

shows. Then press     or     to exit.

VISO Settings

Padlock Window

• Preset jump counter 

• Reset jump counter

• Turn the VISO OFF

• Padlock window

To enter the Setup Area

Perform ACCESS on     or     or     . Then hold     > 5 seconds

Performing ACCESS:

1 Press     or     or     and release quickly. The padlock icon turns ON and OFF

2 When the padlock icon turns ON again, immediately press the same button and  

  keep it pressed (padlock turns OFF)

3 When the padlock icon turns ON again, release immediately

VISO Settings