Larsen & Brusgaard VISO User Manual - Altitude Offset
Altitude Offset
Alti-Meter/Speed-Meter • Feet/Meter when set to Alti-Meter • Mph/Kmh when set to Speed-Meter •
Altitude
offset • Dive Type • True Airspeed (TAS)/ Skydiver’s Airspeed (SAS) • Set current year • Set current date • Set
current time • Preset jump counter • Reset jump counter • Turn the VISO OFF • Padlock window
Explanation
If the DZ landing elevation differs from that of the aircraft take off elevation, offset
the VISO prior to entering the aircraft as follows:
VISO Settings
Altitude Offset
Press and hold or to offset the current altitude.
Press to save setting and enter the
Dive Type selector.
Note: When performing altitude offset, the VISO enters Jump Mode and the altitude
offset will be retained for hours, if no jump is made. After hours the VISO recali-
brates to the field elevation where it is currently located.
The altitude offset is not retained when the VISO is powered OFF.
Mph/Kmh Selector
Alti-Meter/Speed-Meter • Feet/Meter when set to Alti-Meter •
Mph/Kmh when set to Speed-Meter • Altitude
offset • Dive Type • True Airspeed (TAS)/ Skydiver’s Airspeed (SAS) • Set current year • Set current date • Set
current time • Preset jump counter • Reset jump counter • Turn the VISO OFF • Padlock window
Mph/Kmh
VISO Settings
Press or to toggle between Mph/Kmh.
The active selection flashes.
Press to save setting and enter
Altitude Offset.
Note: Jump data is continuously stored in both Mph and Kmh.
At any time stored information may be displayed in either unit
of measurement by selecting the respective mode.