LaserPro Spirit GE Maintenance Manual - page 45
Other manuals for Spirit GE:
User Manual
Manual is about: Engraver
of
60
44
corroded.
It is recommended that the X-rail should be cleaned daily or after each day’s operation.
The Y-rail requires the same type of cleaning and greasing about once a week. Use a piece of
non-abrasive cloth to swipe and clean the rails. Then apply a small amount of the PS2 grease
on to the rail and swipe it clean again.
PS2 grease MZ01417A
Please note that there are two rails on the X rail.
There are 2 rails on the Y-axis as well.
Distributed & Supported by: Jorlink USA, Inc. | Tel: (336) 288-1613 | support@jorlink.com | www.JORLINK.com
45/60