LaserPro Spirit GE Maintenance Manual - page 58
Other manuals for Spirit GE:
User Manual
Manual is about: Engraver
of
60
57
When the first LED from the left turns “ON”, check that the RF cable is
connected.
When the third LED from the left turns “ON”, either the laser head or the RF
cable is bad.
When the fifth LED from the left turns “ON”, the RF power supply has gone over
temperature.
For 30W models:
Only the two right most LEDs are used for 30W models. Under normal
condition, all LEDs will not turn “ON”.
Distributed & Supported by: Jorlink USA, Inc. | Tel: (336) 288-1613 | support@jorlink.com | www.JORLINK.com
58/60