LaserPro Spirit GE Maintenance Manual - Section 2. Error Lights
Other manuals for Spirit GE:
User Manual
Manual is about: Engraver
of
60
55
Section 2. Error lights
Identifying problems by looking at the lights on the mainboard.
The LED circled in green is the 5V light. This light should always be
“ON“ showing that there is a 5V supplied to the mainboard. Check that the power
supply next to the mainboard that provides the 5V power is working properly if it
is not “on”.
Distributed & Supported by: Jorlink USA, Inc. | Tel: (336) 288-1613 | support@jorlink.com | www.JORLINK.com
56/60