Leadtek GPS 9537 Quick Manual - page 18
_______________________________________________________________________________________________
- -
16
Q: Why is the GPS device not found by the PDA map utility program after positioning is
completed by the “Navigator”?
A: “Navigator” is an application utility that users can use to test for GPS. After using
“Navigator”, you have to disconnect the GPS device in order to release the COM Port
before proceeding with the positioning by your PDA map utility program. Otherwise, the
COM Port will still be occupied by “Navigator”, and the PDA map utility program will not find
the GPS device.
Q: Why I can’t get the positioning to work with my GPS at home or areas by the
windows.
A: GPS is really used for outdoor positioning navigation, and the satellite signal is difficult to
be received at home. Especially, it takes a while to get the positioning to work for the very
first time. Therefore, positioning must be done outdoors where satellite signal can be
received.
Q: How can the Leadtek GPS 9537 BT Receiver signal and battery power level be
identified?
A: When the power is turned on, the Bluetooth signal is blue and it flashes. After Bluetooth
is connected with PDA, the Bluetooth signal flashes rapidly and even appears to be constantly
on. The Bluetooth signal turns green and blinks at a rate of once per second when GPS
positioning is completed. If the battery is running out of power, then the Bluetooth signal is
red when the power is turned on. In the case of low battery, turn off the device and recharge
the battery. The Bluetooth signal is constantly red when charging, and the signal will
automatically be set off once the battery is fully recharged.
Q: Why can’t I install “Navigator” application utility in my PDA?
A: “Navigator” application utility can be installed directly in most of the PDAs. For those
PDA models that have installation problems, you can search for a file called
Navigator.ARM.CAB, among the installation files. Copy this file to any folder in your PDA,
and install “Navigator” application utility by clicking on the file directly.