Leckey LS240-04 User Instructions - page 14
8.3 Pelvic Cradle
8.4 Gluteal ramp
When setting up the Pelvic Cradle for the
first time with the client in it, the Pelvic
Cradle should be flat and open before the
user is placed into the Kit Seating System.
All four side and back buckles should be
already attached to the seat. When the client
is placed in the seat, first fasten the buckle
(A) at the front of the Pelvic Cradle. Then
fasten the Velcro (B) at the sides to fit the
Pelvic Cradle to the user. Then adjust the
front and rear straps (C) and (D) to secure to
position the user’s pelvis.
After initial set up, only the front
buckle (A) needs to be released when
the user is transferred in or out of the KIT
Seating System.
Once a week, check that the Pelvic Cradle
has not become slack.
If a gluteal ramp (A) is required, it can be
attached by Velcro to the front of the
Pelvic Cradle before the user is placed into
the seat.
A
C
D
B
B
A
8.5 Sacral Support
The sacral support can be adjusted in a
number of ways - height, depth and angle.
To adjust the height or the depth, remove
the spine upholstery shroud and loosen the
two screws (A) on either side of the bracket.
Move the sacral support to the required
position, height and depth. Retighten the
screws and replace the spine upholstery
shroud.
To adjust the angle of the sacral support,
loosen both the screws (B) on the ball and
socket joint. Position the support at the
required angle. Retighten the screws.
A
B
B