Ledj Q Batten LEDJ300 User Manual - page 5
4 CHANNEL MODE
Channel
Value
Function
1CH
0-255
Red 0-100%
2CH
0-255
Green 0-100%
3CH
0-255
Blue 0-100%
4CH
0-255
Amber 0-100%
7 CHANNEL MODE
Channel
Value
Function
1CH
0-255
Master dimmer
2CH
0-255
Strobe
3CH
0-255
Red(0-100%)
4CH
0-255
Green(0-100%)
5CH
0-255
Blue(0-100%)
6CH
0-255
Amber(0-100%)
7CH
0-4
No function
5-80
Colour Macro
81-150
Colour change
151-255
Colour fade
5.4 Optional CA-8 Easy Remote control
The easy remote control is used only in master/slave modes. By connecting to
the remote socket of the first unit you will find that the remote controller on the
first unit will control all the other units in Standby, Function and Mode.
5.5. Optional IR Remote
Button functions:
The “BLACKOUT” button is used to set the LEDs into the power on or off
modes.
The “S PR” button is used to run the built-in programmes. To go though the
built-in programmes, press the “+” and “-” buttons.
The “FL” button is used to set the LEDs to flash on and off, to change the flash
fre-quency use the “+” and “-” buttons.
The “SP” button is used to set the run speed, this button is available only in the
colour change or colour fade modes. To change the speed use the “+” and “-”
buttons.
The “D” button is used to set the LEDs into DMX mode. (See DMX value table)
The “SA” button is used to set the LEDs into sound activated mode.
The “SL” button is used to set the LEDs into slave mode.
The “S”, “0”, “1”, “2”, “3”, “4”, “5”, “6”, “7”, “8” and “9” buttons are used
to set the DMX address for the LED’s.
Stand by
Blackout the unit
Function
1. Synchronous Strobe
2. Sound Strobe
Select show
Select Colour
Mode
Strobe(LED OFF)
Show(LED ON)
LED Blinking