Lockwood Digital Deadbolt User Manual - Unpack The Lock
6
Battery Cover
Inside Escutcheon
Inside Escutcheon & Mounting Plate
(with gasket)
Outside Escutcheon
1
2
3
Figure 3B
Figure 3A
B. Bolt
notE: Bolt ships with backset in 60mm
position. If required, press small black button
on underside of bolt and pull to extend to
70mm backset position (Fig. 3B).
The lock is packed representative of how it will install on the
door.
Before installing the lock on the door:
A. Inside escutcheon
1. Loosen the screw (Phillips #2) holding the battery cover.
(The screw remains attached to battery cover)
2. Slide the battery cover up and out (note the two tabs at
bottom of battery cover).
3. Remove the inside mounting plate (with gasket) from the
back (door side) of the inside escutcheon.
a. Ensure that gasket on both Outside
Escutcheon and Inside Mounting
Plate (Figure 3A) is properly fitted.
Use either Rubber gaskets for doors
37-50mm thick or Plastic gaskets
for doors 32mm-36mm thick.
C. The outside escutcheon (with gasket remains assembled).
Unpack the lock
Prepare lock for installation