Magicar 2W9000PRO User Manual - page 5
Page 8
More Button Functions
(1) Time Setting
Beep sound for confirmation
STEP 1
(II+III)
-
2 sec
Button
PressedFor
Function
Time setting is on.
The numbers flash. Beep Sound.
STEP 2
(I)
(II+III)
-
1/2 sec
Change time.
Change minutes.
Time setting is off. Beep sound.
You may continue for motion
option.
STEP 3
STEP 4
(I)
(II)
1/2 sec
1/2 sec
2 sec
Page 9
(2) RPS & Vibrator on or off
Note :
The step 2 has to be completed within 15 seconds.
Beep sound for confirmation
STEP 1
(II+III)
-
2 sec
Button
PressedFor
Function
STEP 2
RPS on or off, beep sound for
confirmation.
Vibrator on or off, beep sound for
confirmation.
(III)
(IV)
1/2 sec
1/2 sec
Remote-Pager Learn Routine
If you replace or add additional remotes, you can program up to three remotes,
please perform the following procedure:
Step1 :
Activate Valet/Programming mode by manually turning the ignition
on and off five times
(between Acc and On)
with car key within a 10 second period.
The parking light will flash once with successful
completion of this step.
Alarm Mode
You can arm or disarm alarm mode by pressing Button
i
for a 1/2 second.
Press Buttons
HiKiiI
for a 1/2second to make your car siren mute when arming or
disarming your vehicle. Keep in mind that your car siren will still activate for all
other modes (i.e. panic, alarm, shock sensor) regardless of whether or not your car
siren is in mute mode. The car siren will be mute only when arming or disarming
your vehicle. In alarm mode, the
starter kill function
(this maybe an optional
feature provided by your installer) is activated.
This feature disengages the starter mechanism on your car that prevents you
from starting your car even with a manual key when your vehicle
Ŗ
s alarm mode is
activated.
Note :
If you lose your remote after you have armed the vehicle, use your key
to open the vehicle. The siren will go off. Turn on and off ignition 5 times
with your key to shut off the siren and turn the system into valet mode.
Cancel the valet mode with remote later. See Valet mode.
Note :
(Siren duration is 30 to 60 sec depending on the options set at the time
of initial installation.)
Step2
:
Within a 10 second period after cycling the ignition for the 5th time,
press button I. The car parking lights will flash once to confirm
that the transmitter has been programmed. Continue program the
additional remotes. The parking lights will flash two times when
the programming mode is expired.