Magicar 2W9000PRO User Manual - page 9
Optional Auxiliary 1 & Auxiliary 2
The auxiliary system is an optional car feature that can be tailored for your vehicle
by your local authorized MAGICAR dealership. For example, you can customize
your car to have remote power control of your windows, radio, and sunroof in
addition to the rooftop on your convertible car.
Page 17
OPTIONAL INSTALLATION FEATURES
The MAGICAR 2W9000Pro, 2W9000Pro-2
nd
remote-pager has additional features and
expansion possibilities that require additional parts and labor.
Cold Start Mode
If the optional temperature sensor has been installed,
Timer Start
Mode becomes Cold Start Mode, Under this mode, your car automatically starts if
the temperature of the inside of the vehicle goes below the preset temperature.
The minimum interval between the starts will be 1.5 or 3.0 hours depending on
preset options during the time of installation. Cold Start Mode is activated or
deactivated by pressing Buttons
HiiKivI
for a 1/2 second.
Passive locking means the door will lock when the system passively arms.
In the default factory setting, the system is armed and locked actively, which means
the system will only arm/lock when the remote-pager is utilized.
Note:
1. If you select both Auto Arming and Passive Arming, Auto
Arming takes priority over Passive Arming.
2. If you select Passive Arming with Active Lock in the
programming option, you are also selecting Auto Arming
without Auto Lock.
Consult your installer.
Page 16
Turbo Mode
If this optional Turbo Mode has been programmed at the time of installation,
you can turn this feature on and off by pressing Buttons
(III+IV)
for a 1/2 second.
Under this mode, engine continues running for 2 minutes after key has been taken
out from the ignition if emergency brake was on when the key is taken out.
To utilize this mode, the emergency brake sensing wire has to be connected to the
emergency brake wire of the vehicle. Consult the authorized dealer for this mode.
2
nd
Car Mode
The Remote-Pager is able to operate 2
nd
vehicle.
Press buttons
III&IV
simultaneously for 1/2 second. If this mode is turned to
2
nd
Car, the Remote-Pager will not communicate with the 1
st
vehicle.
To Exit 2
nd
Car press button
III&IV
simultaneously again.
(Consult your Authorized Dealer)