Magicar M871A Installation Manual - Remote Control Programming
Entering valet mode with PIN code.
1. Armed.
2. By opening the door, the alarm will be triggered. Siren will chirp.
3. Within 3 sec turn the ignition on/off three times.
4. Lights will flash once.
5. Push the button on RPS as many times, as your first number is. Intervals between the
click/pushes must not be longer than 1.5 sec.
6. Lights will flash once.
7. Push the button on RPS as many times, as your second number is.
8. Lights will flash twice. Siren is off.
Valet mode is activated.
Valet mode available functions:
Button I (0,5s) – door lock/unlock
Buttons I+III (0,5s) – Valet mode
Button IV (0,5s) – Car status check (only armed/disarmed)
Button III (2x short push) – 10 sec. the remote display backlight.
Buttons II + III (2s) – Programming the remote menu.
If you try to set any other function, the remote will beep 3 times and will be displaying
„SLEEP“.
Valet mode deactivation.
You can deactivate valet mode only by using the remote control:
•
Push together shortly buttons I and III.
•
Siren will beep once and lights will flash twice.
VIII. REMOTE CONTROLS PROGRAMMING
Remote control programming
1. Disarmed.
2. Within 3 sec turn the ignition on/off three times. The lights will flash once. Now you are
in valet/programming mode
3. Within 6
seconds press shortly button l on your remote control. Lights will flash once to
confirm programming.
4. The same way as in step 3, program remaining remote controls. Lights will flash once
to confirm each remote. System will automatically exit the programming mode after
acceptation of the third remote or within 6 sec, which will be signaled by two flashes of
the lights.
Note !!!
When programming new remote controls, the old ones will be automatically erased. If you
have only one remote, it is not necessary to program it 3 times.
Security code setup
Conditions for primary setup of security code!
Function in Programming menu 1-04 must be set.
Disarmed
ignition on /
Doors opened
engine off
12