Magicar M871A Installation Manual - page 13
EN
EN
Programming of security code (1111-9999):
1. Ignition on.
2. Open the door.
3. Push the button on RPS sensor 10 times. At every single click, LED will flash red
once. Intervals between the click/pushes must not be longer than 1.5 sec.
4. Blue LED will start flashing rapidly. If it does not happen, go back to step 1.
5. Push the button on RPS as many times as your first number between 1-9 is. After
each push red LED will flash.
6. After entering the digits, wait until LED will confirm the number by a correspondent
number of blue LED flashes.
7. Blue LED will start flashing rapidly. Push the button on RPS as many times as your
second number between 1-9 is. At each push of the button red LED will flash once.
8. After entering the digits, wait until LED will confirm the number by a correspondent
number of blue LED flashes.
9. Continue by repeating steps 7, 8 for entering the third and fourth number of your
code.
10. After entering the fourth number, lights will flash to confirm that the program code
has been accepted.
Changing PIN code
PIN code is set as the factory default code (11). PIN code must be inserted to enter Valet
mode after turning key on/off 3 times if you have already selected “PIN code ON” from
optional table.
Procedures of change PIN code from the factory default code 11 to owner’s own code
1. System is disarmed.
2. Maintain the conditions of the trunk and the door being opened.
3. Within 3 sec turn the ignition on/off three times. Lights will flash once. Siren makes
a long beep.
4. Push the button on RPS as many times, as your first number (1-9) is. Intervals
between the click/pushes must not be longer than 1.5 sec.
5. Siren beeps once. Lights will flash once.
6. Push the button on RPS as many times, as your second number (1-9) is.
7. Siren beeps twice. Lights will flash twice.
8. Press button IV on remote for authentication. Siren beeps three times and lights will
flash three times.
IX. WIRING DIAGRAM FOR DOOR LOCKING SYSTEM
Fig.1 Original built-in central power lock with a switch
inside the doors. A motor at the control level are
required.
Fig.2 Original central power lock & electric power lock
switch inside the front doors..
13
+12V
Unloc
k
Lock
yellow/black
yellow
yellow/white
green/black
green/white
green
NC1
NC2
COM1
NO1
COM2
NO2
CN2
CN2
Front door switch
yellow/black
yellow
yellow/white
green/black
green/white
green
NC1
NC2
COM1
NO1
COM2
NO2
Unloc
k
Lock
+12V