Magicard Pronto User Manual - page 3
ID Card Printer – User Manual
- 3 -
The information contained in this document is subject to change without notice.
Magicard Ltd shall not be liable for errors contained herein or for incidental consequential damages in connection with the
furnishing, performance or use of this material.
This document contains proprietary information belonging to Magicard Ltd and may not be wholly or partially copied, stored
in a data retrieval system,or used for any purpose other than that for which it was supplied, without the express written
authority of Magicard Ltd. All rights are reserved.
The HoloKote feature is protected by US PATENT No: 5,990,918 and by EUROPEAN PATENT SPECIFICATION EP 0 817
726 B1.
Microsoft and Windows 2000, XP, Vista, Windows 7, 8 and 10 are trademarks of Microsoft Corporation.
Copyright © 2010 Magicard Ltd.
SAFETY INSTRUCTIONS
To prevent electric shock, do not remove covers.
Do not attempt to service the Printer yourself.
There are no User serviceable parts inside. In the event of malfunction, refer servicing to your ID Card Printer supplier’s
Service Centre.
For safety reasons, your Printer should only be used with its original supplied Power source.
Take care not to spill any liquid on the Printer.
Ensure that the Power Supply cable is not longer than 2 metres in length and includes a properly earthed connection.
When handling the Printer, avoid touching the thermal printing edge of the Print Head. Any grease and contamination will
shorten it’s life.
Before transporting the Printer, remove the Dye-Film & Card Hoppers and pack the Printer in it’s original packaging.
If using this printer in Germany :
To provide adequate short-circuit protection and over-current protection for this Printer, the building installation
must be protected by a 16 Amp Circuit Breaker.
Bei Anschluß des Druckers an die Stromversorgung muß sichergestellt werden, daß die Gebäudeinstallation mit
einem 16 A-Überstromschalter abgesichert ist.