Magma EXPRESSBOX 3400 User Manual - page 14
ExpressBox 3400
Install Expansion Interface card
By default the Expansion Inte
need to install the Expansion Interface card.
If you need to replace the Expansion Interface card or install a new
steps below:
1. Turn off the Expansion chassis first.
2. Unscrew the Expansion Interface card.
3. Install the new Expansion Interface card
4. Plug-in the Expansion Interface card in
card. Installing the Interface card in
NOTE
Host Interface card (HIF), is the same exact card as th
SW4 switch on the Expansion Interface card
NOT function if SW4 is set to OFF=HOST. See picture below
Make sure to check that the dip switch (SW4) is set to proper configuration. The toggle switch should be
to “ON=EXP” position, see picture below.
ExpressBox 3400 | Chapter 2 Hardware Installation
Interface card (STEP 2)
By default the Expansion Interface card is already installed.
need to install the Expansion Interface card.
Interface card or install a new Expansion Interface card follow these
Turn off the Expansion chassis first. Disconnect the power cord.
card.
new Expansion Interface card.
card into PCIe slot#0. This is the designated slot for the Interface
card. Installing the Interface card into a non-designated slot can cause the system to malfunction.
Host Interface card (HIF), is the same exact card as the Expansion Interface card (
Expansion Interface card is set to “ON=EXP.” The expansion system will
to OFF=HOST. See picture below for SW4 dip switch setting.
the dip switch (SW4) is set to proper configuration. The toggle switch should be
below.
Magma
Chapter 2 Hardware Installation
14
rd is already installed. No
Interface card follow these
nterface
malfunction.
e Expansion Interface card (EIF). The
system will
dip switch setting.
the dip switch (SW4) is set to proper configuration. The toggle switch should be set