Magma EXPRESSBOX 3400 User Manual - page 20
ExpressBox 3400
Cable Configuration
Attach Power Cord (STEP 6)
NOTE
If at all possible, plug the power cord
computer into a shared power strip, preferably one that has surge and noise
suppression circuitry built into it.
1. Make sure the Power Switch is turned OFF
3400.
2. Turn power supply switch to ON position.
ExpressBox 3400 | Chapter 2 Hardware Installation
You can only connect the PCIe cable to
of the Interface card.
Note: Do not plug in the PCIe cable to x16 port, the
expansion unit will not operate.
the power cord from the expansion chassis and your host
computer into a shared power strip, preferably one that has surge and noise
suppression circuitry built into it.
the Power Switch is turned OFF first before connecting the power cord to ExpressBox
er supply switch to ON position.
Magma
Chapter 2 Hardware Installation
20
cable to the x8 port
o not plug in the PCIe cable to x16 port, the
on chassis and your host
ExpressBox